Monito network connections on mac terminal

The ' p' is the bus number of the ethernet card and the ' s' is the slot number. The ' en' simply means 'ethernet' just like 'eth' does for eth0. The interface name depends on the physical location of the hardware. ItвЂ™s been used on systemd-based Linux systems for some time. The new naming scheme is referred to as the вЂњPredictable Network InterfaceвЂќ naming. If you're wondering why it's called enp0s25 on this system instead of the likely more familiar eth0, a little explanation is in order.

The normal network interface is more interesting. We can see the loopback IPv4 address (127.0.0.1) and the loopback IPv6 ( ::1) in the listing. The 'lo' interface is clearly the loopback. The two interfaces on this system - the loopback (lo) and network (enp0s25) - are displayed along with a lot of stats. Valid_lft 57295sec preferred_lft 57295sec

When you use the ip a (or ip addr) command to get information on all the network interfaces on your system, you're going to see something like this: $ ip aДЎ: lo: mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 The ip command has a lot to tell you about the configuration and state of your network connections, but what do all those words and numbers mean? LetвЂ™s take a deep dive in and see what all the displayed values are trying to tell you.

Monito network connections on mac terminal